CHEMICALS OUTLOOK: Paraxylene banks on China downstream demand recovery in H2

Banner Image

The paraxylene market will be counting on a much awaited return of Chinese downstream demand in the second half of the year, as sentiment remains sluggish on the back of capped buying interest, growing supplies and a weaker-than-expected draw of aromatics from Asia to the US for blending into gasoline.

Chinese downstream demand has done little to stoke any optimism in the market despite high expectations at the start of the year.

A much anticipated pull of aromatics from the US for blending into gasoline also fizzled out leading to PX prices moving lower in the run-up to the summer driving season while stuttering consumption trends in the US did little to bolster sentiment. With the driving season nearing commencement and despite a recent improvement in consumption trends in the US, there is limited scope for a last minute pull of PX and other aromatics cargoes from Asia given longer shipping times involved.

Currently, margins for PX producers have remained stable with the spread between CFR Taiwan/China PX and C+F Japan naphtha holding above $350/mt though down from a record high of $483.83/mt on March 20, 2023.

Market participants suggest that the spread could continue to stay perched above $350/mt for the next few months which could provide some incentive to PX producers to maintain operating rates in the second half of the year.

However, growing supplies remain a concern as plant turnaround season ends and current capacities come back online though no new PX plants are expected in China for the second half of the year.

So far in 2023, PetroChina's Guangdong Jieyang plant commenced operation with a capacity of 2.6 million mt/year along with CNOOC Daxie having a capacity of 1.5 million mt/year.

The operating rates for these plants was fairly limited which helped cap supplies but are expected to rise steadily over the next few months. Meanwhile, CNOOC's new plant in Huizhou is expected to commence operations in June for its 1.5 million mt/year plant.

The only likely support emerging so far for PX prices is the growing capacity of PTA plants in China and the fairly high operating rates for polyester manufacturers.

Polyester producers in the country have raised operating rates back up to around 92% as more PTA plants come online and steadfast optimism that Chinese demand recovery is not too far away.

"I think China is currently supported by intention of PTA makers to run [so] that could support PX for now," a trader in China said.

Post China's re-opening after the COVID-19 induced lockdowns, market players were expecting strong demand growth especially from Q2 2023 onward.

But with little of that materializing so far, the focus has now shifted to Q3 2023 though some market participants have even written off 2023.

"I am actually looking at 2024 [since] 2023 is almost done," a PTA producer in China said.

The early promise of China's reopening was reflected in the sharp rise in PX prices at the start of the year and vigorous buying trends visible in the market. But as reality of lackluster Chinese demand became increasingly evident, the enthusiasm began to wane.

The global economic situation will also be watched, as fears of a recession continue to loom large on the horizon.

Struggling economies in both US and Europe have dampened Chinese polyester exports further, weighing on sentiment.

Chinese domestic consumption has shown marginal improvement but remains low for polyester finished goods so far. Furthermore, the weakness in key Chinese export markets such as the US and Europe spurred by the ongoing economic downturn have also crushed demand for polyester finished goods.

Even China's economy is being cautiously watched with eyes on employment rates, domestic consumption trends and thirst for travel within the country.

Market participants remain hopeful of a turnaround in the Asian giant's fortunes by Q3 while domestic gasoline consumption could surge during the upcoming long holidays in October.

Weak eurozone

In Europe, demand in the PX spot market is expected to remain weak, coupled with weak downstream demand from PTA and PET markets which is likely to weigh on the latter's consumption.

Due to cooler-than-expected weather in May, alongside inflation eating into end-consumer purchasing power, consumption of PET bottles has remained lower than normal in the region.

With PET consumption remaining sluggish within the continent, the impact will also be felt on demand for PX and PTA.

Production of PX for spot consumption is also touted to remain low within Europe amid poor economics given the stiff competition faced from comparatively better priced Asian product.

"Big producers won't produce until 2024" a distributor said.

US' gasoline bet

On the US front, PX imports found some support in the early part of 2023 on expectations of healthy blending demand in the run-up to the summer driving season.

Paraxylene imports rose 80% on the year in the first quarter of 2023, according to US International Trade Commission data.

PX imports totaled 270,048 mt in January-March, higher than 149,904 mt in 2022.

However, the initial euphoria seemed to quickly fizzle out as weak consumption trends in the US amid bearish macroeconomic fundamentals. Furthermore, refiners in the US were also much better prepared this year compared to the previous year with a gush of imports seen last year unlikely to repeat itself.

PX exports fell 24% on the year to 191,776 mt.

Tags

  • Chemicals

Related content

News

WPC: Energy transition faces discord amid geopolitical pressures

Geopolitical pressures — including rising resource nationalism and a year in which over 50% of countries will be having elections — as well as inflationary pressures have sent energy transition progress into “discord.” A specialty chemicals panel session held March 19 at the World Petrochemical Conference by S&P Global in Houston, Texas, tracked the challenges and opportunities of the energy transition for the industry. Speaking at the session, Roman Kramarchuk, head of climate markets and policy analytics at S&P Global Commodity Insights, said that if the short-term scenario continues, global temperatures could rise 2.4 degrees Celsius by 2100, far above the Paris Agreement’s goal of a 1.4-degree increase. “Over the past few years, we’ve certainly been trending more towards our ‘discord’ scenario,” Kramarchuk said. “We’re trending toward a longer runway for fossil fuels and less [greenhouse gas (GHG)] emission reductions. This is a case of less GDP growth, less trade and less technology transfer.” Since 1990, world GHG emissions have grown 45%, with mainland China, India and the Middle East representing the biggest increases in emissions, at 304%, 241% and 181%, respectively. Over the last 25 years, the Commonwealth of Independent States and the EU have cut their emissions the most, with decreases of 39% and 31%, respectively. The US has cut emissions 1% since 1990. Of S&P Global Commodity Insights’ three energy and climate scenarios, only one, “green rules,” has global temperatures near the Paris Agreement’s 1.5-degree goa, with an expected increase of 1.7-degrees Celsius by 2100l. The “green rules” scenario, however, assumes more technology transfer, cooperation and policy-driven outcomes than is currently happening. “2030 is not that far away,” Kramarchuk said, “and when you think about what the energy transition will take, solar panels can be constructed fast, but anything beyond that — like an onshore or offshore wind plant or a nuclear unit — we’re getting into lead times of 5, 10, or 20 years.” While the US Inflation Reduction Act has helped speed these transformational energy products along, there are still a lot of slowdowns in permitting, especially in Europe. “We joke that there needs to be a ‘Complexity Reduction Act’ in Europe to move things forward,” Kramarchuk said. Harald Schwager, deputy chairman of Evonik Industries AG’s executive board, added that companies are stuck in a hard place. Evonik has signed power purchase agreements (PPAs) to be powered fully by renewable energy by 2030. “The question will be, will production capacity be hampered by the regulatory process and will we have sufficient infrastructure in place to transport enough renewable power for site demand by then,” Schwager said. Distant peaks Commodity Insights’ energy and climate base case pegs the peak years for coal, oil and gas demand to be 2022, around 2030 and 2040, respectively. “When there is a surprise need for energy,” Kramarchuk said, pointing toward the COVID-19 pandemic and a drought in China, which caused a boost in coal usage, “fossil fuels fill that need.” However, “there’s more investment in renewable capacity than we’re seeing in upstream oil and gas,” Kramarchuk said. Under all scenarios, renewable electricity will be the lion’s share of newly generated energy sourcing. Rebecca Liebert, president and CEO of Lubrizol Corp., said that it is the duty of specialty chemical producers to be agile and proactive in bringing innovative and more sustainable products to market. “Political and technical factors are all things we must account for in our bring-to-market timelines. And we get it right a lot of times, but we get it wrong some of the time. Sometimes you get to market before the market is ready for your product. And I think that’s great, to have a solution on the shelf as the market comes along.” Schwager agreed: “In the specialty chemical industry, we have more good ideas than we have money. And there’s no regret on moves for improved efficiency.” While there has been little movement on target setting and market-based mechanisms for growing renewable energy, COP28’s first global stocktake committee called for “countries to contribute to triple global renewable energy capacity and double global energy efficiency by 2030.” “Even though we are heading for the discord path right now, with all the technology solutions and innovation pushes, we’ll be shooting up ahead towards the ‘green rules’ scenario in the long-term,” Kramarchuk concluded. This article was first published in chemweek.com .

News

BASF's Finnish pCAM plant start delayed due to permit appeals

Two NGOs appealing against permits Initial plan was to start end of 2023 BASF is facing a delay of the operational start of its newly built precursor cathode active materials (pCAM) plant in Finland due to two non-governmental organizations (NGOs) appealing against already-granted permits, a spokesperson for the German petrochemicals company confirmed to S&P Global Commodity Insights Feb. 27. BASF initially aimed to start commercial production at the Harjavalta plant at the end of last year. “The necessary permit to operate this plant has been granted last year by the relevant authorities,” the spokesperson said. “However, two NGOs have filed an appeal against the already granted permit. Next steps and timing will depend on the furtherance of the judicial process before the Vaasa Administrative Court,” said the spokesperson. The pCAM plant will use renewable energy resources, including hydro, wind and biomass-based power and will be supplied with nickel and cobalt from Nornickel’s adjacent refinery. The plant is part of BASF’s plan to supply the battery industry and subsequently automotive industry with lower carbon emission cathode active material. Platts, part of S&P Global Commodity Insights, assessed cobalt metal in-warehouse Rotterdam at $15/lb on Feb. 26, stable from the previous assessment Feb. 23, while the nickel-cobalt black mass EXW Europe payables was at 54% Feb. 26, also stable.

News

Interactive: Chemical Connections: Mapping chemical pathways and pricing

The petrochemical landscape has been transformed in recent years by new technologies and the global energy transition, resulting in numerous production pathways and the development of more sustainable products. S&P Global Commodity Insights has created Chemical Connections , an interactive chart which shows the links between chemicals, from upstream feedstocks to derivative products. The second slide offers a map showing our price assessments and benchmarks for chemicals across the value chain around the world. These prices are used by market participants daily to write contracts, monitor their markets and achieve full transparency around transactions.